Products >Protective Flooring / Coating Systems >Protective Coatings >ASODUR-3333PW

ASODUR-3333PW

2-Component, non-toxic, moisture tolerant, solvent-free, chemical resistant epoxy protective coating suitable for contact with potable water

Properties:

ASODUR-3333PW is 2-component, solvent-free (100 % solids), nontoxic, epoxy resin-based, high-build, high-performance, chemical-resistant protective coating suitable for contact with drinking water and foodstuffs. After application and curing ASODUR-3333PW provides a durable protective, sealing & decorative, easy to-clean film with excellent abrasion & chemical resistant properties. ASODUR-3333PW is based on selected epoxy resins & special hardener that resist amine blush. ASODUR-3333PW is available in standard white & blue colours. Any RAL shade upon request.

Areas of Application:

ASODUR-3333PW is formulated to provide a continuous protective coating with abrasion & chemical resistant properties and is formulated for lining and
waterproofing of surfaces that will contain potable water or foodstuffs. ASODUR-3333PW is suitable for areas where a thick film is required such as:

  • Water tanks & reservoirs and silos.
  • Food processing areas.
  • Dairies & kitchens.
  • Soft-drink bottling.
  • Storage tanks.
  • Wet processing areas and laboratories.
  • Clean rooms.

Advantages:

  • Easily applied by brush or roller or spray.
  • Solventfree (100 % Solids), low VOC; odorless.
  • Non-toxic and suitable for contact with drinking water or foodstuffs.
  • Highly durable and corrosion-resistant.
  • Moisture insensitive; can be applied on damp surfaces. Excellent abrasion and impact resistance. Forms a hygienic, impervious and seamless coating.
  • Easy to clean surface.
  • Excellent adhesion to sound concrete & masonry substrates.
  • High chemical resistance to most common chemical reagents.
  • Can be reinforced with glass fiber to increase mechanical properties.
  • Excellent resistance to water, waste water and salt water.

Technical Data:

  • Appearance: Pigmented free
  • Specific gravity: flowing liquid
  • Solids content: 1.4-1.5 at20°C
  • Mix ratio: 100 % by weight
    Component A: 100
    Component B: 19
  • Application temperature: 0 – 40 °C
  • Time between coats: 12 – 24 hours at 25°°s
  • Potlife: C70 mins at 25 °C
  • Full cure: 7 days at 25 °C
  • Abrasion resistance: 91.6 mg
    (Taber Abrasive,
    1000 grams /
    1000 revolution)
  • Bond Strength: > 4.ON/mm2

Product Details

Product Application:

Surface Preparation

All surfaces must be sound, clean and free from dust, grease & oils, curing agents, mould release agents and other contaminations adversely affecting bond with the substrate. Steel or metal surfaces should be free from rust or scale in accordance with SA 2&2 (white metal finish). All adhesion preventing contaminants should be fully removed prior to application of the primer (Please refer to “Priming”).

Product Priming:

Priming

Prior to application of ASODUR-3333PW, use as appropriate INDUFLOOR-IB 1 280 or INDUFLOOR- IB1285 {refer to relevant data sheet).

Product Mixing:

Mixing

Stir each component of ASODUR-3333PW well before mixing. Pour the entire contents of Component B into the Component A container and mix well for 2 to 5 minutes until a uniform consistent colour is achieved.