Products >Concrete Restoration & Repair Mortars >Concrete Restoration >ASOCRET-BIS-1/6

ASOCRET-BIS-1/6

Mineral-based fine repair mortar for 1-6 mm voids

Properties:

  • Impermeable to water
  • Water vapour permeable
  • Frost fast and resistant to de-icing salts
  • Very good working properties
  • Application by trowel or spray
  • Reduces CO2 penetration
  • High resistance to carbonation

Areas of Application:

ASOCRET-BIS-1 /6 is used for horizontal and vertical areas as well as overhead areas as a non-sag fine repair mortar for voids up to max. 6 mm. It is furthermore suitable as a levelling compound for swimming pool tanks and other tanks as well as for forming pool edge details for the subsequent application of bonded waterproof membranes or the installation of tiles.

Storage:

cool and dry, 12 months in the original unopened packaging.
Use opened packaging promptly.

Technical Data:

  • Basis: factory blended dry mortar
  • Colour: cement grey
  • Grain size: up to 0.5 mm
  • Pot life*: approx. 60 minutes
  • Overcoat after: min. 1 day
  • Substrate/application temp: min. +5 °C, max. +30 °C
  • Compressive strength: 24 hrs, approx. 16 N/mm2
    7 days, approx. 32 N/mm2
    28 days, approx. 40 N/mm2
  • Flexural strength: 24 hrs, approx. 2 N/mm2
    7 days, approx. 7 N/mm2
    28 days, approx. 8 N/mm2
  • Consumption: approx. 1.6 kg/m2/mm thickness
  • Cleaning: Thoroughly clean work tools with water after use
  • Packaging:25 kg bag

Product Details

Product Application:

Application by hand

Apply a scratch coat of ASOCRET-BIS-1/6 to the prepared substrate and then lay to the desired thickness. Striking off the mortar is determined by the application involved using a suitable tool (lath, trowel etc} within the pot life. After leaving for the appropriate length of time, the surface can be finished using a feltboard or sponge-board.

Product Wet Spray Application:

Wet spray application

The surface to be treated must be adequately wetted until matt-damp. Re-profiling with wet spray techniques is carried out after mixing in a compulsory mixer with a suitable feed pump using a 12 mm spray reprofiling gun or a 35/12 mm MAWO nozzle. For an even spray pattern a high output construction compressor (min. 4 m3 air / 4-5 bar operating pressure) is a mandatory requirement.

Product Mixing:

Without compulsory mixer

Pump system: High Comp Power
Pump unit: XP 120
Water demand: approx. 160 – 180 |/hr
Nozzle: MAWO nozzle 35/12 mm or 12 mm re-profiling spray gun
Max. Pipe length: 30 m
Control nozzle displacement: 0.5 – 1.0m