Properties:

Two component, low solvent, moisture tolerant epoxy resin.
Water vapour impermeable.
Due to its high density, INDUFLOOR®ST 1100 displaces the water from the surface capillaries of concrete substrates and acts as a barrier to oil rising through capillary action.
Forms a very good bond to damp concrete substrates. Prevents penetration of radon.

Application Method:

Using a rubber squeegee, apply ASODUR-SG2 to saturation onto the cleaned, matt damp substrate and thoroughly work into the surface with a priming brush and back roll with a short nap paint roller. Blind the fresh primer with quartz sand (grain size: 0.5 – 1.0mm diameter). Once hardened, carefully remove all non-bound quartz sand before subsequent coatings are applied to the primer.

Primary Uses :

As a special priming treatment for oil-contaminated but previously cleaned concrete substrates.
As effective protection against the formation of osmosis bubbles when there is moisture
penetrating from the rear.
As a capillary breaking grout to the pool edge with high-level water tables, up to 1:1 filled with 0.1–0.6 mm quartz sand.
As a priming treatment for concrete/bonded screeds that are still damp, which are to receive floor coverings such as PVC, linoleum, carpet, parquet, tiles etc. Please refer to the advice section.
As a primer for SOLOPLAN® 30-PLUS.

Technical Data:

Basis: two-component epoxy resin.
Color:light grey..
Viscosity:70 s in a 4 mm DIN standard cup..
Mixture Ratio:100:12 parts by weight.
Density:1.86 g/cm3..
Pot Lifeapprox. 60 minutes at +23ºC, approx. 30 minutes at +30ºC.
.

INDUFLOOR®-ST1100

Properties:

Application Method:

Primary Uses :

Technical Data: