ASO®-Tape (INDUBOND-Tape-3000)
THERMOPLASTIC JOINT TAPE FOR WATERPROOFING JOINTS
- product data sheet
- download data sheet
Properties:
- Highly flexible.
- Simple, homogenous weld.
- No activation necessary
- Impermeable to water even against negative pressure.
- Can be applied to matt damp substrates without priming.
- Resistant to frost, UV and ageing
Areas of Application:
Coat the prepared substrate on both sides of the joint to be bridged with ASODUR-K4031 to a width min. 1 cm wider than the ASO®-Tape being used. Then lay the joint tape and thoroughly bed into the adhesive layer with a trowel or pressure roller without voids or folds and coat over the top. In so doing, ensure that the joint tape is completely bedded. The adhesive or smoothing coat thickness should never be less than 1 mm. Overlap butt joints by a min. of 5 to 10 cm and bond or alternatively hot air weld.
Application Data:
The substrate must be clean and load-bearing as well as free from adhesion-inhibiting materials. At the time of installation, it may be matt damp but not wet or with saturated pores. In the area to be waterproofed, mechanically prepare the substrate using suitable means e.g., planting, scabbling or grit blasting etc., in order to ensure a good bond. When using on a substrate other than concrete, assess with a trial adhesion test.
Technical Data:
- Basis:TPE (Thermoplastic Elastomer).
- Color:Grey.
- Shore A Hardness to ISO 868 :approx. 87.
- Temperature resistance:-30ºC/ +90ºC.
- Application, substrate and material temperature:+5ºC to +35ºC.
Product Details
It is essential that there is at least 8 cm
It is essential that there is at least 8 cm coverage of concrete from the side exposed to water. Bond AQUAFIN-CJ6 with a mounting adhesive suitable for waterstops. Completely cover the prepared substrate with the mounting adhesive and press the AQUAFIN-CJ into the adhesive until it oozes out from beneath. Do not begin the concreting process for at least 8 hours after bonding.
Waterstop connections can be made
Waterstop connections can be made by overlapping by 50 mm or by butt jointing. The waterstops must be placed tightly together to prevent gaps. But jointed waterstops must be covered by a separate section of waterstop with a 30 mm overlap to both sections.