Products >Tile & Natural Stone Laying >Tile Adhesive >MONOFLEX

MONOFLEX

Flexible Cement Based Tile Adhesive, grey

Properties:

MONOCELEX is a high grade, polymer-modified, thin bed adhesive, tested and supervised according to EN 1 2004, for interior and exterior applications. MONOEFLEX is easily workable, with a high initial bond and has very good stability. Due to its flexible form, application is also suitable on weak deformable
surfaces.

Areas of Application:

MONOEFLEX is used as a tile adhesive for thin layer methods for ceramic coatings (even fine earthen ware), mosaic, clinker, brick tiles and insulating plasterboards. For translucent materials MONOFLEX white is recommended. MONFELEX is suitable for the application on masonry, plaster, gas concrete, concrete and gypsum board as well as on old tiles. MONOFLEX is suitably flexible for surfaces such as heating screed (see special technical leaflet), precast concrete (at least two months old) and dry construction boards such as gypsum boards etc. MONOFELEX is suitable for the tile laying on composite sealed surfaces in interior applications according to ZDB-leaflet.

Storage:

Storage for at least 12 months, use opened bags immediately.

Technical Data

  • Basis: Sand/cement (plastic modified)
  • Filler structure: Fine sand
  • Colour: Cement grey
  • Bulk density: approx. 1.25 kg/|
  • Pot Life: approx 1hr
  • Application temperature: +5° Cup to +30° C
  • Skin formation*: approx. 25 minutes
  • Traversable*: After approx. 24 hours After
  • Jointable*: approx. 24 hours
  • Cleaning: In green condition with water
  • Official tests: according to EN 12004 supervised by MPA
  • Consumption: depending on surface and tiles ,minimum 1.2 kg/m2 in dry
  • Packaging: 25 kg bags with PE inlet 6 kg bag (6 bags in one cardboard box)

Product Details

Product Application:

Surface preparation

The surface must be dry, resp. moist, load bearing and free from dirt, dust and release agents. Further information is available in DIN 18157, part | is to be adhered to. Prime absorbent substrates with ASO-Universal. Smooth concrete surfaces have to be roughened, anhydrite screed are to be abraded and primed with ASO-Universal Primer.

Product Preparation:

MONOEFLEX is mixed with tap water

MONOEFLEX is mixed with tap water until a lump free, pasty mortar is obtained.

Mixing ratio:

1.00 | water to 4 kg MONOFLEX

6.25 | water to 25 kg MONOFLEX

Do not cover more surface than is required, keeping within the handling time of up to two hours. The ready to use adhesive is applied with surface continuity and troweled with a suitable serrated trowel. The tiles are fixed with light pressure.