Products >Protective Flooring / Coating Systems >Primers & Sealers >INDUFLOOR-IB1285

INDUFLOOR-IB1285

Non-toxic, low viscosity, solvent-free, moisture tolerant, 2 component, pigmented epoxy resin-based penetrating primer & sealer, suitable for contact with portable water

Properties:

INDUFLOOR-IB1285 is a low viscosity, non-toxic, 2-component, solvent-free (100 % solids), odourless, low VOC, moisture-tolerant, pigmented epoxy resin- based primer and sealer. INDUFLOOR-IB1285 is suitable for use in potable water structures. INDUFLOOR-IB1285 is formulated to prime & seal concrete and masonry substrates where high performance is required. Additionally INDUFLOOR-IB1285 is part of the multi- flooring system, INDUFLOOR-IB3359 where high adhesion to porous concrete surfaces is fundamental.

Areas of Application:

INDUFLOOR-IB1285 is typically used for:

  • Priming & sealing of concrete and masonry surfaces.
  • Adhesion promotion between substrates and subsequent applications such as but not limited to: epoxy coatings, self-level floor toppings, floor screeds & PU floor systems.
  • Bonding epoxy flooring to concrete, steel, and masonry.
  • Sealing concrete substrates; enhanced protection against chemical reagents, water and water-soluble salts.

Advantages:

  • Easily applied by brush or roller.
  • Low VOC; odourless.
  • Solvent-Free (100% Solids)
  • Non-toxic; suitable for contact with potable water.
  • Pigmented to ensure full coverage visually.
  • Rapid cure even at low temperatures, dampness or humid conditions.
  • Superior adhesion to dry & damp surfaces.
  • Excellent tensile & flexural strengths.
  • Low viscosity; ensures effective penetration &strengthening of surface.
  • Excellent anti-corrosion properties.
  • Excellent resistance to water, waste water and saltwater.
  • It will perform as a waterstop membrane (moisture vapour barrier)

Technical Data:

  • Appearance (mixed): Light grey liquid
  • Specific gravity: Light grey liquid
  • Solid content: 100 % by weight & volume
  • Application temperature: 5 °C – 40 °C
  • Pot-life: 60 mins at 25 °C
  • Full cure: 7 days at 25 °C
  • Bond strength to concrete : > 4 N/mm2
  • As a “primer”: 0.25 – 0.40 kg/m2 (*)
  • As a “sealer”: 0.25 – 0.55 kg/m2 at 2 coats (*)

Product Details

Product Application:

Mixing

Stir well, each of the components (separately) prior to the mixing of the two components. Empty the entire content of component B into the canister of component A. Using an appropriate drill attached with an approved mixing paddle, mix (RPM approx. 300) the entire contents well for at least 3 to 5minutes, until a uniform colour and consistency is achieved.

Product Placement:

Placement

Apply the properly mixed INDUFLOOR-IB1285 onto the prepared substrate using a suitable brush or roller. Airless spray equipment can be used in case of large areas. Whilst the coating is still tacky apply the subsequent floor coating, self-level floor topping, floor screed or PU flooring system. If INDUFLOOR-IB1285 dries out, re-prime before commencement with the subsequent layer.