Properties:

Penetrates the capillaries in concrete.
Continually active.
Can be applied to damp substrates.
Chloride free.
Resists high levels of hydrostatic pressure.
Carbonatisation barrier.
Waterproofs retrospective cracks up to 0.4 mm.
Test certificates to German DVGW worksheets W 347 and W 270 are available.

Areas of Application:

Exterior and interior waterproofing in cellars, lift shafts, foundations, retaining walls.
Waterproofing containers for drinking and service water, retaining basins, water treatment plants, garages, tunnels etc.
Waterproofing beneath screeds (unbonded screeds or floating screeds).

An analysis of the water is necessary where the hardness degree is < 3° dH. AQUAFINAC is resistant against strong chemical attack (exposure class XA2 to DIN 4030).

Storage:

12 months when stored dry and frost free in the original unopened packaging. Use opened packaging promptly.

Technical Data:

Basis: sand/cement, additives grey
Colour: 1.1 kg/|
Bulk density: 25 kg AQUAFINIC to 6.75
Mix: to 8.0 litres clean water 3 minutes
Pot life: (at +23° C / 60%)
Dry film thickness: min. 0.8 mm-1.5 mm
Substrate/Application temperature: min. +5° C to max. +35° C. Lower temperatures extend, higher temperatures reduce curing times.
Mixing time: (drill with 500 – 700 rpm) 30 to 60 minutes
Packaging: 25kg bags
Cleaning of tools: With water when in the fresh state, remove dried material with ASO-Steinreiniger.
Material consumption Dry film thickness: min. 0.8 mm-1.5 mm
Ground moisture/non standing drainage water: 0.75 kg/m² in one coat
Non-hydrostatic pressure: 1.2 kg/m² in two coat
Consumption may increase on uneven substrates
Ready for exposure at +20° C and 60% relative humidity:
to rain after approx. 24 hours
to foot traffic after approx. 5 hours
backfilling the building trench after 3 days
filling containers after approx. 7 days

Product Details

Product Application:

Dry shake application

AQUAFIN-IC must be broadcast at the coverage rate appropriate for the expected water exposure (see under Material consumption’ on to freshly poured concrete. For large areas it is recommended that the floor be marked into bays with known area. Sufficient AQUAFIN-IC should then be laid out to meet the recommended spread rate. Once the concrete has started initial setting (light foot traffic imprint of 3-5 mm) apply AQUAFIN-IC immediately. When AQUAFINIC absorbs the concrete moisture entirely and a uniform darkening of colour takes place, start trowelling of the surface (helicopter smoothening).

Product Application by Brush:

Application By Brush

Spread two coats of AQUAFIN-IC at the required quantity in a slurry consistency with a roofer ’s brush or builders brush. Brush thoroughly and evenly, working into the substrate. Apply the second coat whilst the first coat is still tacky and hasn’t dried out

Product Spray Application:

Spray Application

AQUAFIN-IC can be applied with the aid of suitable compressed air spray equipment, e.g. with the HighPump MB [peristaltic pump], Highpump Small or HIGHPUMP Pictor (spiral pump] from HIGH TECH, Berlin. Dependent on the final wet duty of the installation spray apply one or two coats in a circular motion. Apply the second coat whilst the first coat is still tacky and hasn‘t dried out

AQUAFIN-IC

Crystalline Waterproof Slurry