Products >Waterproofing System >Joint Tapes >ASO®-Joint-Tape-2000

ASO® Joint-Tape-2000

ASO® -Joint-Tape-2000-Corners

Properties:

  • Composite material
  • Elastic
  • Tear resistant
  • Impermeable to water
  • Thin build-up
  • Water vapour permeable
  • UV stabilised
  • Very low emissions
  • Highly resistant to aggressive media
  • Guarantees the quick drying of adhesives and waterproof membranes, which contain water

Areas of Application:

ASO-Joint-Tape-2000 is used for forming waterproof movement joints and junctions in waterproof membranes such as e.g. SANIFLEX, SANIFIN, AQUAFIN- 1 K-flex, AQUAFIN-2K, AQUAFIN-2K/M, AQUAFIN-RS300 and ASOFLEX-AKB. ASO-Joint-Tape-2000 is easy to use, vapour permeable and forms an integral bond with the named waterproof membranes.

ASO-Joint-Tape-2000 fultills the requirements of the DIBt test principles and the ZDB data sheet “Bonded waterproot membranes”, which are valid for wet duty classes A, B and C.

Storage:

24 months when stored cool and dry protected from sunlight and weather influences

Technical Data:

  • Basis:composite material fleece-membrane fleece
  • Colour:white with SCHOMBURG lettering
  • Weight:approx. 150 to 190 g/m2
    Internal angles
    approx. 3.5 g / piece
    External angles
    approx. 5 g / piece
  • Tolerated movement accommodation: max. 30% of the joint width
  • Sd-Value: < 30m ± 5m

Product Details

Product Application:

Joint waterproofing, wall and floor junctions and bay defining movement joints:

Using the waterproof membrane, bond ASO-Joint- Tape-2000 or ASO-Join-Tape-2000 internal /external angles for use in comers, at the transition between wall and
floor as well as interface joints, to the prepared area without voids or folds. Where structural movement joints / movement joints cross over, ASO-Joint-

Tape-2000-T sections or ASO-Joint-Tape-2000 crosses are available, which permit them to be laid in a looped formation at cross over points. Butt joints must be overlapped by 5 to 10 cm. Ensure that a watertight connection between
the wall and the surface applied waterproof membrane is produced.

Product Coat:

Coat both sides of the joint to be bridged with

the waterproof membrane to a width of at least 2 cm wider than the waterproof tape, e.g. with a 4 – 6 mm notched trowel.